Difference between oil seal and o ring12/7/2022 ![]() Based on the studies of the mechanical behavior of rubber, the degradation process of rubber and the material reliability is studied. studied the mechanical behavior of rubber material influenced by long-term aging and cycling. Lee and Huang tested the rubber material and worked out the mechanical behavior of the rubber material. Besides, many researchers have studied the reliability analytical methods for the O-ring. These standards provided evidence for analyzing the reliability of the O-ring. Thus, on the basis of existing analytical methods, the reliability analysis of the O-ring can improve the accuracy of reliability evaluation and ensure the safety of the structure with the consideration of both material degradation and random load.ĪSME (American Society of Mechanical Engineers) and ASTM (American Society for Testing and Materials) published the standards of seal rings based on material performance and sealing performance, which separately defining the material reliability and seal reliability. The traditional reliability analysis methods only focus on the material or load with a single variation on the O-ring, which does not reflect the influence of both material degradation and random load. The O-ring used in hydraulic systems can prevent the leaking of hydraulic oil and protect the piston from coming into contact with the inner wall of the cylinder block and being scratched. Seals are widely used in hydraulic systems. The results show a lifetime of 12 months for the O-ring calculated in this paper, and compared with the replacement records from the maintenance workshop, the result is credible. Finally, the life prediction and effect of oil pressure were discussed, then compared with the actual situation. Thirdly, compressive stress and contact stress have been calculated, which was combined with the reliability model to acquire the time-variant reliability for the O-ring. Following this, the time-variant material properties through experiments and load distribution by monitoring the processing can be obtained. Firstly, the two factors are defined in terms of material failure and seal failure, before the experimental methods of rubber materials are studied. In this paper, two factors are mainly analyzed: the degradation of material properties and load randomization by processing technology. While traditional methods can only analyze one of the material properties or seal properties, the failure of the O-ring is caused by these two factors together. Due to the increase in working hours, the reliability of rubber O-ring seals used in hydraulic systems of transfer machines will change. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |